Durafly TUNDRA V2 - Control Throws and Flap Settings

Control throws:
Elevator
8-14mm
8-14mm
8-12mm
8-12mm
50-60mm
10-20mm
10-20mm
Rudder
Aileron
*Elevator: ‘low rates’ 8mm, ‘high rates’ 14mm in either direction from neutral.
*Rudder: ‘low rates’ 8mm, ‘high rates’ 12mm in either direction from neutral.
*Ailerons: ‘low rates’ 10mm, ‘high rates’ 20mm in either direction from neutral.
3. The
Tundra V2 handles very well in flight and that’s not down to good design alone, but a good
pre-flight set-up too. Before you fly your Tundra please follow the recommended settings below
for optimum handling and performance.
4. Flaps on the Tundra will need to be set for 3 stages (up/no flap, mid flap and full down flap). Either
via your radio or mechanically by turning the clevises on the flap control rod (or via both in most
cases), set mid flap to approximately 45 degrees and full flaps to approximately 90 degrees to the
wing. In the ‘up/no flap’ position ensure the flaps close fully without straining the servos and are
both level with the trailing edge of the neutral ailerons. Also check that both flaps deploy equally
at every stage.
9
50-60mm
Flaps
90 degrees
45 degrees