1. Out of the box your Tundra comes with reinforced foam hinges. However before assembly can
begin, each hinge line must be flexed back and forth 5-6 times to reduce tension and load on the
servo. Do this for all control surfaces before continuing.
2A. To mount the undercarriage to the fuselage, start by inserting and securing the two rear braces
with supplied M2.5x8mm screws (A). Now insert the main gear wire into the fuselage slot and
slide the plastic brace keepers over the rear braces (B) to bring these two parts together. Insert
the spring support wire between the main gear wire (C) . Using supplied M2.5x8mm screws
secure the main gear and spring support wire in place with the plastic undercarriage straps (D).
Notes:
- Ensure the main gear rakes forward at stage B.
- Note left (L) and right (R) marked plastic straps and install accordingly during stage D.
Assembly (PNF)
3
B.
C.
D.
A.
M2.5x8mm
M2.5x8mm
To Next Page
Loading...
