877-534-5157 | GraphicProducts.com 4
WI-FI SETUP
Toro Max comes with a USB Wi-Fi adapter to allow it to be connected to your local network.
To set up this connection:
1. Open the Wi-Fi controls by clicking on the wireless icon in the toolbar, or navigate to the Settings menu from the main screen
and choose Networking.
2. Make sure the Wireless option is switched on (showing orange). A list of available wireless networks will appear. (If your Toro
Max is already connected to a wireless network, there will be a checkmark next to the entry for that network.)
3. Select your preferred wireless network. If the network is protected by a password, you will be prompted to enter it; then, click
“Connect.”
To remove saved details about a network, click the gear icon for that network’s entry in the list, and choose “Forget Network.”
Graphic Products
®
, DuraLabel
®
, PathFinder
®
, Toro
®
, Toro Max
®
, Bronco
®
, Lobo
®
and Kodiak
®
are Registered Trademarks of Graphic Products, Inc. ©2021. Graphic Products, Inc. grants a
limited revocable right to reuse portions of the material contained herein for non-commercial, internal, and educational/training use. Any use beyond that described here requires the
written consent of Graphic Products, Inc. Licensee agrees to reproduce the Trademark, Copyright, and Legal disclaimers in all works created under this license.
To Previous Page
Loading...
