6 DU_M_P3 Comforts_16.04.01
Installation
Mark the drain opening.
Cut drain flange about 1 7/8“ to fit against
the wall. Drill 8 pilot holes using 1/4“ drill bit,
about 5/8“ inside from the edge.
Cut opening for the drain flange. Place and secure drain flange to subfloor with
screws. (Screws are not supplied)
1
3
4 5
Put the plug in the drain. Apply first coat of
paintable waterproof membrane. Apply
membrane up the wall and in the corners, and
make sure to thoroughly coat the entire drain
flange. The membrane requires to be applied up
the wall a minimum 6“.
6
Inspect the shower tray for any damage that
may have occured during transport.
2
To Next Page
Loading...
