Durr Dental VS 300 S - User Manual

Questions and Answers

T
Thomas GeorgeAug 3, 2025
What to do if my Durr Dental Medical Equipment does not start?
- D
  David AndersonAug 4, 2025
  If your Durr Dental Medical Equipment isn't starting, there could be several reasons. First, check the mains voltage to ensure it's properly connected. If the voltage is low, measure the supply voltage and consult an electrician if needed. Also, verify the control voltage at the signal input. Finally, a defective capacitor could be the issue; measure the capacitance and replace it if necessary.
L
Laura JohnsonAug 12, 2025
Why is the suction performance too low on my Durr Dental Medical Equipment?
- C
  connor70Aug 12, 2025
  If the suction performance of your Durr Dental Medical Equipment is too low, it could be due to a blocked coarse filter. Clean the coarse filter at the intake connection. Another cause might be a leak in the suction line; check the suction system and connections for leaks. Also, the turbine may have mechanical sluggishness caused by soiling, so you should disassemble the unit and clean the turbine.
R
Rachel McclureAug 25, 2025
How to stop unusual noises from Durr Dental Medical Equipment?
- S
  Stephen ColeAug 25, 2025
  Unusual noises from your Durr Dental Medical Equipment can stem from several causes. The turbine might be blocked by solid particles or sticky soiling, so disassemble the unit and clean the turbine. Also, check the membrane valve at the waste water connection and clean or replace it if necessary. Ensure you're using non-foaming cleaning and disinfectant agents to prevent foam in the turbine. Check the pipe system to avoid over-cooling that can cause build-up of condensate in the exhaust air line. Lastly, clean the waste water line/siphon trap, if it is blocked.