EasyManua.ls Logo

Durr Dental VSA 300 S User Manual

Durr Dental VSA 300 S
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
EN
VSA 300 S
Installation and operating instructions
0297
9000-606-31/30
*9000-606-31/30*
2101V005

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Durr Dental VSA 300 S and is the answer not in the manual?

Durr Dental VSA 300 S Specifications

General IconGeneral
CategoryDental equipment
Number of treatment units1
Voltage230 V
Frequency50/60 Hz
Power consumption1200 W
Weight45 kg
Max. flow rate300 l/min

Summary

About this document

Warnings and symbols

Explains warning symbols and their structure, including signal words and other symbols used.

Safety

Intended purpose

Defines the suction machine's primary function of providing suction and separating liquids/air.

Intended use

Details where and how the machine is meant to be installed and used, including maintenance.

Improper use

Lists forbidden uses and their consequences, holding the operator liable for damages.

General safety information

General rules for safe operation, including compliance with laws and unit checks.

Electrical safety

Safety regulations for electrical connections and work, including EMC rules for medical devices.

Technical data

Operation

Unit Overview and Function

Describes the unit's components and the two-stage separation system for fluids and air.

Assembly

Commissioning

Service program

Service Program Steps

Illustrates the steps for accessing and performing checks within the service program.

Description of the service program

Service Program ON/OFF

Procedure for activating and deactivating the service program using the service key.

Usage

Amalgam collector vessel status

Details indicators for 95% full, 100% full, and vessel not in position, with recommended actions.

Disinfection and cleaning

Replace the amalgam collector vessel

Risk of contamination and handling

Warns of contamination risk if vessel is reused and recommends changing it in the morning.

Maintenance

General maintenance work

All maintenance must be performed by qualified personnel, with warnings about contaminated units.

Tips for operators and service technicians

Troubleshooting - Device does not start

Lists possible causes like no mains voltage or undervoltage and remedies for device startup issues.

Troubleshooting - Motor fault

Addresses motor faults due to control electronics or sensor issues, with remedies for checking connections and magnets.

Troubleshooting - Unusual noises and water leaks

Covers causes for unit noises like solid particles and water leaks from blocked valves or condensate.

Troubleshooting - Suction performance too low

Identifies causes like blocked coarse filter or leaks in the suction line and suggests remedies.

Transporting the unit

Related product manuals