MAINTENANCE SCHEDULE
The following information is to be used as a guide:
ITEM LUBE METHOD FREQUENCY FIG./PG.
1. Spindles Oil Wipe After Cleaning Fig. 7, Pg. 6
2. Ram Pin Oil Wipe After Cleaning Fig. 7, Pg. 6
3. Linkage Pins Oil Drop After Cleaning Fig. 22, Pg. 9
4. Follower Oil Wipe Yearly Fig. 25, Pg. 10
5. Crank Bearing Grease Pack Yearly Fig. 25, Pg. 10
6. Slide Pins Oil Wipe Yearly Fig. 25, Pg. 10
TROUBLESHOOTING
Problem Solution
Rounding will not take place:
1. Drive belts slipping: -Adjust belts, see Adjustments, Item 2 Page 5.
2. Motor not operating:
a. Motor overload tripped -Set switch to stop position, allow motor to cool, push reset on
lower end of motor. Replace cover, start machine.
-Single phase machines reset is located in the on/off switch.
Push downward on the switch then turn the machine back on.
b. Switch faulty -Replace switch.
c. No incoming power -Check circuit breaker of fuses, incoming power.
3. Lift arm loose: -Reposition and tighten in lower base.
4. Slide rod/drive sticking: -Clean slide rods and lubricate under crank plate.
5. Follower sticking: -Clean follower tracks and lubricate bearings under crank plate.
Dough Balls Vary In Size: -Dough needs to be pressed out with more
pressure on handle.
-Knead or roll dough evenly within the inscribed
circle on the dough pallet before pressing.
Dough Sticks To Head: -Dust the top of the dough only, with a light dusting flour prior to
pressing.
-Head assembly not clean, wash and dry head assembly, see
Cleaning Instructions on pages 8-9.
If a problem should continue AFTER having attempted the corrective SOLUTIONS found on
Pages 10 - 11, Please call the Dutchess Customer Service Hotline Number 1 - 800 - 777 - 4498
11
To Next Page
Loading...