TROUBLESHOOTING
Problem: Solution:
Partial Rounding of Dough Balls
1. Pocket height set too high: -Readjust pocket height, see Adjustments, Pg. 5.
2. Rounding time too short: -Increase rounding time.
3. Pallet is oily or floured: -Wash and dry pallet.
4. Drive Belts slipping: -Adjust or replace belts, see Adjustments, Item 2, pg. 5.
Flour Pocket in Dough Ball: -Use less flour on top of dough.
Imperfection of Dough Ball: -Usually caused by over, or under rounding.
(Normal rounding time: 5 - 15 seconds.)
-Pocket height set too high or too low.
(Raise or lower as needed.)
Rounding Action Will Not Stop:
Rounding lever not returning to
idle position: -Lubricate linkage.
-Check slide springs.
Crank Plate will Not Center: -Adjust drive slide centering, see adjustment pg. 5.
1. Broken slide spring: -Replace spring.
2. Slides/drive slide sticking: -Clean slides, lubricate.
WARNING!
The power switch is to be in the OFF position, and
the machine disconnected from the power source,
before servicing or cleaning.
12
To Next Page
Loading...