Duux Edge - Open Window Detection Function; Timer Function Operation

20
showing that the chosen value is conrmed.
- The product returns to awake mode.
- The thermostat icon lights up on the
display to indicate that the thermostat
function is activated.
NOTICE
• When the heater is actively heating to maintain
the set temperature, the heating icon lights up
on the display.
• The thermostat function can be combined with
the timer function.
7.3.2. Open window detection
When a sudden drop of 5˚C in temperature
within 10 minutes is detected, the product will
stop heating to prevent unnecessarily heating.
The product suspects an open window nearby.
The product makes a long beep sound and all
the function icons on the display turn o. The
display shows the word “OPEN” continuously for
1 minute.
During the 1 minute wait, press any button to
cancel the product from entering standby mode.
The product will resume the current function
settings.
After 1 minute, the product makes a beep sound
and enters standby mode while the word “OPEN”
remains on the display.
Press the power button R to return the product
into awake mode.
7.4. Timer function
The timer function can be used in two ways:
• Turn on timer: Turns on the product
automatically at a chosen time. After a set
amount of time, the product enters awake
mode.
• Turn o timer: Turns o the product
automatically at a chosen time. After a set
amount of time, the product enters standby
mode.
NOTICE
• The timer function can be used without a day and
time being set.
• The timer function can be combined with the
thermostat function.
• The timer function cannot be combined with the
schedule function. Activating the timer function
deactivates the schedule function.
7.4.1. Setting the turn on timer
NOTICE
• The product must be in standby mode to activate
this function.
1. Press and hold the timer button A for 3
seconds.
- The product makes a beep sound.
- Number “0” starts ashing on the display
along with the timer icon .
2. Press the increase button T or the