EasyManua.ls Logo

Duux Edge - Product Installation and Setup; 5.1. Package Contents

Duux Edge
148 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14
5. Installation
5.1. Package content
Check the package contents. If any parts are
missing or damaged, please contact your
supplier.
1 × Duux Edge Heater
1 × Horizontal mounting bracket
1 × Vertical mounting bracket
2 × Floor stand
1 × Remote control
4 × M5 × 10 mm bolt – Philips heads (4×)
4 × 4.2 × 30 mm screw – Philips head (4×)
1 × 3.8 × 8mm screw – Philips head (1×)
4 × 6 × 28 mm plug
NOTICE
Risk of damaging the product. Remove all the
packaging material before assembling or using
the product. Leaving packaging material on the
product may cause melting of the packaging
material and sticking to the product.
5.2. Installation of the product
6
WARNING!
Fire hazard. Never use the product near
ammable materials or surfaces. The product
may become hot while in use. Keep the product
at a minimum distance of 1 meter away from
ammable materials or surfaces.
6
CAUTION!
Risk of short-circuiting. Never use an extension
cord. Only use the product on a direct power
source.
Risk of short-circuiting. Never locate the product
immediately below a power outlet. The product
may become hot while in use. Always keep the
area above the product free from objects and
power outlets.
Risk of short-circuiting. Never use the product in a
humid environment. Always use the product in a
clean and dry environment.
This product can be used with the oor stand or
mounting bracket.
5.2.1. Required tools
Screwdriver
Power drill
6 mm drill bit
Hammer
Pencil
Measuring tape

Table of Contents

Related product manuals