Why is the water from my Dux 26ENG5L too hot?
If the water from your Dux Water Heater is too hot, make sure the gas and water supply valves are fully open. Check if the water temperature setting is appropriate. If the water supply temperature is high or only a small amount of hot water is demanded, the temperature might be higher than the setting on the remote controller.
How to fix fluctuations in hot water temperatures with my Dux Water Heater?
To address fluctuations in hot water temperatures with your Dux Water Heater, set the water temperature between 48°C and 50°C to ensure a higher flow of hot water, meeting the minimum flow requirement of 2.5 L/min. Also, clean the inlet water filter to remove any debris.
Why is the water from my Dux Water Heater not hot enough?
If the water from your Dux Water Heater is not hot enough, ensure that the gas and water supply valves are fully open. Also, verify that the water temperature setting is appropriate.
What to do if hot water is not available from my Dux Water Heater?
If hot water is not available when you open a fixture, check if the gas and water supply valves are fully open. Also, verify the water supply isn't cut off, the hot water fixture is sufficiently open, the gas isn't being cut off by the gas meter (check if other gas devices work), and (for LP systems) there's enough gas in the tank. Ensure the inlet water filter isn't clogged and that the operation button is turned on.
How to troubleshoot a Dux 26ENG5L that does not attempt to ignite?
If your Dux Water Heater doesn't attempt to ignite, check for reversed plumbing or crossed pipes. Also, inspect the inlet water filter.
What to do if my Dux 26ENG5L Water Heater attempts to ignite but fails?
If your Dux Water Heater attempts to ignite but fails, reset the unit and try again. If the problem persists, have a professional check the gas supply pressure.
Why is the water cold from my Dux Water Heater when only one fixture is open?
If the water is cold when only a single fixture is open with your Dux Water Heater, it's because the unit won't heat the water if the flow rate is less than 2.5 liters per minute. To resolve this, open the fixture more or open other fixtures to increase the flow through the unit, which should then start heating again.
Why is no water available when I open a fixture connected to my Dux 26ENG5L?
If no water is available when a fixture is opened, it might be because the water supply is cut off. Check if the heater is frozen.
General| Brand | Dux |
|---|---|
| Model | 26ENG5L |
| Category | Water Heater |
| Language | English |
To Next Page
