DV Mark DV MICRO 50 II - Speaker out

9
REAR PANEL - DV MICRO 50 JAZZ
10) AC POWER SOCKET Make sure the unit is grounded; all three terminals of the AC power plug must be connected to avoid any injury to the user
or damage to the unit
.
11) VOLTAGE SELECTOR The DV MICRO heads feature a 120V/240V Voltage Selector to use the amp in countries with different voltages,
so make sure the switch on the rear panel is on the correct voltage before connecting it to the AC power, and the fuse is the right value for that
voltage (not available on the 100V version manufactured for Japan).
Please change the voltage/fuse values label located near the voltage selector matching the voltage/fuse values when you need to change the
voltage of the unit.
12) FSW
1/4” MONO jack for connecting a SINGLE
footswitch to turn ON/OFF the reverb
13/14) SEND/RETURN The send/returncan be
used for connecting with outboard effect processors
or pedals. Simply connect the Send out to your pro-
cessor’s input, and connect the output of your pro-
cessor to the Return in.
15) SPEAKER OUT The two speaker ouputs pro-
vided for speaker cabinet connections are wired in parallel and total minimum impedance load for the amp is 4 ohms, so you can connect one or two
8 ohms speakers or only one 4 ohms speaker.
Use speaker cable (not instrument cable)..
Drive Bass Hi
Level
Reverb
Level
Bass
Mid
Hi
PhonesAux
Input
Clean
―
Overdrive
Overdrive
Clean
DV Micro
50 CMT
Off
On
leveldrive bass
hi reverb
level bass mid
hi
phonesaux
input
clean
―
drive
Micro 50
M
off
on
SPEAKER OUT
MIN LOAD 4Ω
RETURN SEND
FSW
CLASS 2 WIRING
VOLTAGE
120
240
SPEAKER OUT
MIN LOAD 4Ω
RETURN SEND
FSW
CLASS 2 WIRING
VOLTAGE
120
240
JAZZDV MICRO 50 JAZZ
15
16
17
18 19
20 20
1
7
2
6
5 13
4
3
8
9
10
11
12
14
1
7
2
6
5 13
4
3
8
9
10
11
12
14
1
7
2
6
5 13
4
3
8
9
10
11
12
14
1 2 5 8
4
3
6
15
16
17
18 19
20 20
15
16
17
18 19
20 20
10
11
12
13 14
15 15
6
7
9