DV Power RMO40TD - DV-Win Software

23
RMO40TD DV-Win Software
7 DV-Win Software
DV-Win is a Windows program developed to work with RMO40TD Tap Changer Analyzers & Winding
Ohmmeters. It enables the two-way communication between RMO40TD and a PC over the USB.
DV-Win supports the following functions:
 Controlling and starting RMO40TD when tests are performed from the PC; the results could be
stored to PC; results reading interval is adjustable,
 Transfer of test parameters from internal RMO40TD memory to the PC.
Note: While using DV-Win software, RMO40TD can only be operated from DV-Win. All buttons on the
front panel of RMO40TD device are locked, except the STOP button.
Data transferred from RMO40TD can be:
- Downloaded in the grid in the form of a table,
- Saved as a PDF, XLS, DOC or RTF file,
Every test reading contains:
- The date and the time of the test,
- The transformer connection (if selected),
- The test mode,
- The real test current,
- The measured resistance values,
- The measured voltage values,
- The measured ripple values,
- The transition time values,
- The tap changer positions,
- The memory location.
7.1 System Requirements
7.1.1 Minimum Configuration
Processor: Intel Pentium IV 1GHz
Memory: 1 GB
OS: Windows XP, Windows Vista or Windows 7
7.1.2 Recommended Configuration
Processor: 2 GHz
Memory: 2 GB
OS: Windows XP, Windows Vista or Windows 7
7.2 DV-Win installation
To install the DV-Win software do the following:
- Connect the RMO40TD to the PC via USB cable and turn the RMO40TD on
- Insert the DV-Win installation CD into the CD-ROM drive,
- Click 
- Click 
- Click 
- Select the CD-ROM drive,
- Highlig-