DVB Elite Series User Manual

6400 SYCAMORE CANYON BLVD.
RIVERSIDE, CALIFORNIA 92507
855-680-9595
WWW.DV8OFFROAD.COM
PRODUCT
INSTALLATION MANUAL
ELITE SERIES D-RINGS
UNSK-01 (BL,RD,GR)
TOOLS REQUIRED SKILL LEVEL TIME REQUIRED
- 3/8” Rachet / Impact
Before you install this kit — Read and understand all
instructions, warnings, cautions, and notes contained in
this installation instruction guide. Consult your vehicle
owner’s manual for proper disconnection of electrical and
lifting of vehicle if required for installation of this product.
This install may require some technical skills and
knowledge of basic mechanical work. If you do not feel that
you are capable of performing this install please take this
product to a trained professional.
After reading this guide please contact us with any
questions or concerns before installing product.
Customer Service: 855-680-9595
DV8 Offroad is not responsible for any bodily injury or harm to you
or your vehicle as a result of an improper install.
Proper installation of this kit required knowledge of the factory
recommended procedures for removal and installation of original
equipment components. We recommend that the factory shop manual
and any special tools needed to service your vehicle be on hand during
the installation. Installation of this kit without proper knowledge of the
factory recommended procedures may affect the performance of these
components and the safety of the vehicle
• Always wear eye protection when operating power tools
Inspect all contents of this package to make sure product is not damaged
and all installation hardware has been included. If parts are missing from
kit, please be prepared to provide the following information
1. Name of purchase location
2. Bar Code on side of box
3. Date above bar code
4. Date inside box cover
- Easy
- 1 (you) person
Little skill level required, you can
easily install it by yourself.
- 3 minutes per side.
Time to install this should only
take about 6min total.
WARNINGS/CAUTIONS BEFORE STARTING INSTALLATION
855-680-9595
NEED HELP?

DVB Elite Series Specifications

General

Brand	DVB
Model	Elite Series
Category	Automobile Accessories
Language	English

Summary

Warnings and Cautions Before Starting Installation

General Installation Guidance

Read all instructions, consult vehicle manual for proper procedures.

Technical Skill and Professional Advice

Assess technical skills; seek professional installation if uncertain.

Pre-Installation Inspection and Contact

Inspect kit for damage/missing parts; contact for questions before installation.

Safety Precautions

Always wear eye protection when operating power tools.

Installation Steps

Step 1: Prepare Shackle and Isolators

Unscrew pin, remove isolators from shackle; use 3/8" tool if needed.

Step 2: Select Correct Isolators

Identify correct isolators by fitting them between bumper mount and shackle.

Step 3: Insert and Screw Pin

Feed pin through shackle and mount, then begin screwing it into the shackle.

Step 4: Secure the Pin

Tighten pin with a 3/8" ratchet/chuck until secure and cannot be loosened by hand.

Step 5: Final Check and Testing

Double-check pin security; D-Ring is ready for testing.