WEAR SAFETY GEAR!
This manual will guide you step by step performing a
seal service and casting cleaning on a DVO
Diamond. Please follow each instruction carefully to
achieve the best and safest results.
*Always wear your safety gear while working on
suspension products.We care about you, make sure
you wear your safety glasses and protective gloves
while servicing DVO Suspension Products.
Tools needed:
Allen key- 2.5mm
32mm thin wall socket
18mm thin wall socket
Rubber Mallet
Oil Measuring Container
35mm Seal Press
Suspension Clean
7.5 wt Oil
18mm Open end Wrench
IMPORTANT!
USE A THIN WALL SOCKET
OR DAMAGE MAY OCCUR
// Intro // Intro
To Next Page
Loading...
