Use the 18mm socket to loosen the air
side footnut.
Use the rubber mallet and tap on the
footnuts until they are ush with the
casting.
Do not completely remove the foot-
nuts from the casting. Make sure there
is a gap as shown.
The footnuts are now ush with the
casting. The cartridges are now free
from the casting.
Do not completely remove the foot-
nuts from the casting. Make sure there
is a gap as shown.
Remove both adjusters from the
casting.
// pg. 3 // pg. 4
7.
10.
11.
12.
8.
9.
OTT Adjuster/Air Side
Rebound Adjuster/ Damper
To Next Page
Loading...
