.
// pg. 9 // pg. 10
Use the 35mm seal press to install the
new seal.
Grab the foam rings from the oil con-
tainer to insert them under the seal.
Use the rubber mallet to press in the
new seal.
The foam ring will sit under the seal
and right above the upper bushing.
The new dust seals should sit ush in
the casting. Make sure the edges of
the seal are evenly pressed into
casting.
Repeat steps 24-27 for the second
seal.
Apply a thin layer of grease on inside
of the seal.
28.25.
29.26.
30.27.
To Next Page
Loading...
