Dyna-Glo DGE530SSP - User Manual

Questions and Answers

J
Jason CarlsonJul 29, 2025
What to do if the Dyna-Glo DGE530SSP Grill burner will not light with a match?
- K
  Katelyn MoyerJul 29, 2025
  If the burner on your Dyna-Glo Grill won't light with a match, there are several potential causes. First, ensure the match is reaching the burners by using the match holder found in the cabinet door. Also, check the fuel level and refill the tank if necessary. Another potential issue is a poor connection between the valve regulator and LP cylinder coupling; in this case, turn off the grill knobs, close the LP cylinder valve, and check the connection, disconnecting and reconnecting if needed. Finally, the burner inlet may be blocked, so clean the burner inlet (venturi) and burner.
S
Seth ThomasAug 3, 2025
How to fix a Dyna-Glo Grill burner that will not light using the ignitor?
- E
  Elizabeth BurkeAug 3, 2025
  If the burner on your Dyna-Glo Grill won't light using the ignitor, it could be due to several reasons. The igniter electrode may be covered with grease or residue, so clean the ignitor electrode. Also, the igniter electrode may have a loose or disconnected wire, so check the connection and reconnect any loose or disconnected wires. Other potential causes include a cracked or broken ignition electrode (replace ignition electrode) or a dead/faulty battery (replace the battery, ensure it's inserted correctly, check for corrosion, and check wire connections).
L
Leonard NealAug 10, 2025
Why is my Dyna-Glo DGE530SSP producing low heat?
- J
  Joseph AndersonAug 10, 2025
  Insufficient gas pressure to the unit could be the reason your Dyna-Glo Grill is producing low heat. Call a qualified service agency to check the gas supply pressure and correct the pressure.
B
brocksabrinaAug 16, 2025
Why are there excessive flare ups on my Dyna-Glo DGE530SSP Grill?
- P
  psotoAug 16, 2025
  Excessive flare-ups on your Dyna-Glo Grill can occur due to a few reasons: build-up of grease and/or residue on heat tents or in the firebox (clean the grill components); excessive dripping of fat or marinade from food (trim the fat from meat and use non-oil based marinades); or a cooking temperature that is too high (lower the temperature accordingly).
A
Allen SmithAug 21, 2025
What to do if there is no gas flow in Dyna-Glo Grill?
- S
  Susan MartinAug 22, 2025
  If you're experiencing no gas flow or an obstructed gas flow in your Dyna-Glo Grill, start by ensuring the tank valve is fully opened by turning it counterclockwise. Check the fuel level and replace the fuel if necessary. A poor connection between the valve regulator and LP cylinder coupling could also be the culprit; turn off grill knobs, close the LP cylinder valve, and check/reconnect the connection if needed. Lastly, a blocked burner inlet could be the cause; clean the burner inlet (venturi) and burner.