Dyna-Glo DGN486DNC - Attach Warming Rack

13
ASSEMBLY INSTRUCTIONS
23. Insert one end of warming rack (U) onto M6x30
bolt (JJ) and into the hole on lid and rebox
assembly (B). Repeat for other side.
22. Attach one M6x30 bolt (JJ) on each side of lid
and rebox assembly (B). DO NOT fully tighten.
Hardware Used
M6x30 Bolt
x 2
JJ
24. Fully tighten M6x30 bolts (JJ) on each side of lid
and rebox assembly (B).