Dyna-Glo EG7500DG - Description and Specifications; Product Description; Technical Specifications; General Safety Information

3
ITEM PAGE #
PRECAUTIONS - SAFETY GUIDE ................................................. 1
1. DESCRIPTION .......................................................................... 3
2. SPECIFICATIONS ..................................................................... 3
3. GENERAL SAFETY INFORMATION ........................................ 3
4. LOCATING HEATER ................................................................. 5
5. INSTALLATION ......................................................................... 5
6. OPERATING INSTRUCTIONS ................................................. 10
7. MAINTENANCE ........................................................................ 11
DESCRIPTION
Electric utility heaters are designed to meet a variety of heating requirements by switching
a few wires located in the base of the unit. Heat output is 25 589 BTU per hour. Features
horizontal and vertical ow horizontal air ow. Built-in thermostat with overheating safety
thermal cutout.
SPECIFICATIONS
GENERAL SAFETY INFORMATION
CONTENTS OF USER’S MANUAL
This heater requires hardwire installation (no plug). The installation of this
product must be carried out by a certied electrician and in accordance
with all local and national electrical codes.
NOTE: Compatible with a 240V Line Voltage Double Pole Wall Thermostat.
Must be installed by a Certied Electrician.
Read and understand all installation & operation instructions prior to
operating this unit. Observe all safety instructions.
WARNING
WARNING
1. Use only copper wires rated for at least 75ºC.
2. Heater air ow must be directed parallel to or away from adjacent wall.
3. Observe all wall, oor and ceiling clearance requirements.
4. All wiring must be done according to national and local electrical codes. The
heater must be grounded as a precaution against possible electrical shock.
Heater circuit must be protected with proper fuses.
5. The mounting structure and the anchoring hardware must be capable of
supporting the weight of the heater and the mounting bracket (if used).
BTUs: 21,331 / 25,589
Power: 6,250 / 7500W
Volts: 240V / 60HZ