Dyna-Glo EG7500DGP - User Manual

48 pages

Save Page as PDF

To Next Page

Before the rst use of this heater, please read this USER’S MANUAL

very carefully. This USER’S MANUAL has been designed to instruct

you as to the proper manner in which to assemble, maintain, store,

and most importantly, how to operate the heater in a safe and efcient

manner. Please keep this manual for future reference.

CONSUMER: Retain this manual for future reference.

Questions, problems, missing parts? Before returning to your retailer, call our customer

service department at 877-447-4768 8:00 a.m. - 4:30 pm CST, Monday - Friday.

or email us at customerservice@ghpgroupinc.com

IMEG7500DGP-NKA

Electric Garage Heater

INSTALLATION & MAINTENANCE INSTRUCTIONS

CSA C22.2 No. 46-13

UL 2021

7,500W / 240V / 25,590 BTU

EG7500DGP

Questions and Answers

M
mcgeehaileyJul 28, 2025
What to do if Dyna-Glo Electric Heater is not heating?
- A
  Alicia GardnerJul 29, 2025
  If your Dyna-Glo electric heater isn't heating, it could be due to several reasons. First, the overheat protection might have activated; inspect the heater to ensure that air inlets and outlets are not blocked. If they are, clear the blockage, switch off the circuit breaker for 30 minutes to allow the heater to cool, then turn it back on. Second, the breaker may have tripped; reset it at the fuse panel and restart the heater. Finally, the room temperature might have reached the set thermostat temperature; in that case, adjust the temperature setting to be higher than the current room temperature.
O
olivertamiAug 13, 2025
Why does my Dyna-Glo Electric Heater emit a burning smell?
- D
  Dalton MullenAug 13, 2025
  A burning smell from your Dyna-Glo electric heater can occur for a few reasons. Initially, dust or oil debris may have gathered on the heating coils during production. Ensure the room is well-ventilated and allow the heater to run until the smell dissipates. Also, check that there are no combustible materials within 0.9 meters (3 feet) of the heater and remove them if there are. This heater must be mounted at least 8 feet off the floor; relocate the heater if needed to ensure sufficient clearance from walls and the floor.

Summary

Installation and Maintenance Instructions

Important Instructions

Specifications

Safety Information

Locating the Heater

Pre-Installation Procedures

Installation Guide

Mounting the Bracket

Details on securing the mounting bracket to the ceiling or wall stud.

Hanging the Heater

Steps for attaching the heater unit to the installed mounting bracket.

Connecting the Power

Instructions for wiring the heater, including options for external thermostats.

Protecting the Heating Element

Describes how the heater operates when starting and shutting down.

Operating Instructions

Setting the Thermostat

How to adjust the thermostat knob for desired heating.

Selection Switch Operation

Explanation of how to use the selection switch for different wattage outputs.

Thermal Cut-Out Function

Describes the automatic shut-off feature due to overheating.

Adjusting Air Flow Direction

How to adjust the heater's orientation for optimal air circulation.

Maintenance Procedures

Replacement Parts List

Troubleshooting Guide

Warranty Information

Dyna-Glo EG7500DGP Specifications

General

Model	EG7500DGP
Power Source	Electric
Voltage	240V
Wattage	7500W
Amperage	31.25A
Thermostat	Yes
Mounting	Portable
Safety Features	Overheat protection, Tip-over switch
Type	Electric Heater