4 Replacement Procedures 4.13 CCD Module
Satellite C50-H/C40-H Maintenance Manual 4-33
Installing the CCD Module
Install the CCD Module according to the following procedures and Figure 4-33.
1. Remove CCD Module release paper.
2.Connect LCD cable to CCD module connector.
3.After ripping off FPC release paste FPC into shell LCD cover.
4.Seat the CCD Module in the correct position.
5.Route the LCD cables according to Figure 4-29, place the cable into the ditch and
correct position. Avoid to pinching the cables.
To Next Page
Loading...
