NO.
CONT.ON 8 PAGE NO.7
1. Outline
This document describes the specification of “Windows PE Test & Diagnostics”. (Hereafter referred to as “WPETD”)
1-1 Target Model [Rev01] [Rev02]
The target model(s) are as follows:
20A model(s): IP3 YangPass20
/30
1-2 Target OS
WPETD can run on the Windows Pre-installation Environment as follows:
Windows PE 10 19H1 X64
2. Preparation
2-1 Creating WPETD USB memory
Get the ISO image of WPETD released from Dynabook Inc., usually by KIZUNA system.
Burn the ISO image to USB memory. The USB memory will be Windows PE bootable media.
Regarding the USB, use a USB Memory the size of which is 1GB or more.
1) Format USB memory to FAT32 file system.
2) Copy all files of ISO image to USB memory.
2-2 Equipment Configuration for Tests
The following table indicates the equipment configuration necessary for WPETD’s test items.
Test Item Equipment required Remarks
USB PORT USB Memory Free space: More than 12MB
During the test WPETD creates a file in the USB Memory.
ODD An optical medium containing the test data in the
root folder (if the model has the ODD device)
The test data file name need to be as below:
CDDTEST0.DAT
WIRED LAN
Wired router, LAN cable The router must have the DHCP server function.
USB Flash Memory
LAN router
(DHCP Server)
LAN cable
(Straight cable)
Fig.1 Equipment Configuration
To Next Page
Loading...
