NO.
CONT.ON 20 PAGE NO.19
2-2) - it is “YangPass_14_UK” layout as an example
Press all the keys to test the keyboard, and when you presses the Key board, it marks like below:
(Yellow: waiting for test; Green: Tested OK; Red: NG (Break code NOT paired with make code); Blue: Key Down)
3) Result
If you want to end current test as a result of NG, you can click FAIL button or just close (X) the KB Test module.
After clicking FAIL button, it will be display like below:
(Click the “Cancel” button to exit this KB test as a result of NG, or you can also click “Retry” to reset/start over the KB test)
If all the keys are tested OK, this module will automatically exit and has a result of OK.
■ In case of PASS
“OK” is shown in the “Result” field on the “Diagnostics” dialog.
■ In case of FAIL
“NG” is shown in the “Result” field on the “Diagnostics” dialog.
4) Test file
Keyboard.exe: Test program.
To Next Page
Loading...
