NO.
CONT.ON 26 PAGE NO.25
Next, the battery off (Shipping Mode) test/setting starts as above, and it will exit automatically when finished.
3) Test Result
If the test finished and exit automatically, then the test/setting result is OK.
If there is error, then the test/setting will pause and the result is NG.
■ In case of PASS
“OK” is shown in the “Result” field on the “Diagnostics” dialog.
■ In case of FAIL
“NG” is shown in the “Result” field on the “Diagnostics” dialog.
4) Test file
BatteryOff.exe: Test program.
4-2 Aging Tests
The following items are grouped as the Aging tests.
Aging Tests: HDD PHYSICAL, HDD LOGICAL, MEMORY, USB STORAGE, SD STORAGE, ODD, WIRED LAN, CPU, GRAPHICAL DISPLAY,
Timer
These “Aging Tests” are integrated in WPETD (WinPETD.EXE) itself.
Aging Tests start when the all selected Non Aging Tests have finished.
You can run these Aging Tests more than once by setting the “LOOP COUNT”.
If you check “Multitask” check box, all Aging Tests you select run simultaneously. The tests run repeatedly until the last one reaches
the “LOOP COUNT”.
If you un-check “Multitask”, the Aging Tests you select run one by one from the top to the bottom in the list.
Then the cycle will repeat the number of times you set in the “LOOP COUNT”.
Regardless the “LOOP COUNT” you set, if an aging test encounters total 10 errors during the execution, the aging test will
terminate.
To Next Page
Loading...
