dynabook SATELLITE PRO C50-H - Page 75

NO.
CONT.ON 28 PAGE NO.27
Copyright (C) 20
20
Dynabook Inc., All Right
s
Reserved.
“NG” is shown in the “Result” field on the “Diagnostics” dialog.
The pass and error count are shown in the “pass” and” error” fields respectively.
The detail of the error is recorded in the log file as follows.
Message Explanation Remarks
Read Hdd Create File
Error.Address=XX
Failed in opening of HDD/SSD driver.
XX is LAB value.
The HDD/SSD driver may not be normal
or installed.
Read Hdd Set File
Pointer Error.Address=XX
Failed in the HDD/SSD file pointer setting
command.
XX is LAB value.
It indicates that a read error occurred at
the specified LBA.
Read Hdd Command Error.
Address=XX
Failed in the HDD/SSD read command.
XX is LAB value.
Read Hdd Check Size Error.
Address=XX
The size read by the HDD/SSD read command
does not equal to the specified size.
XX is LAB value.
4-2-2 HDD LOGICAL Test
[Rev01]
1) Test contents
This test checks if it can read the files on the first built-in HDD/SSD successfully.
Note that the test does not always read whole data of a file. It reads at most 1 MBytes from the top of the file.
Note that the test is only checking those files that have a file size greater than 0 Bytes and less than 1 MBytes.
■ In case of Simple mode
The simple test mode performs a read test on the first 400 files.
■ In case of Detail mode
The detailed test mode performs read test on the first 2000 files.
The status is updated sequentially (the file name being verified is displayed in “File Name” dynamically) during the test, the test
finished until it reads last file (400
th
file for Simple mode, 2000
th
file for Detail mode) successfully. This is the one cycle of the test. If
you set the pass count more than one, the test runs more than one cycle.
2) Test screen
▼ File Name … The name of the file being verified with full path
3) Result
■ In case of PASS
“OK” is shown in the “Result” field on the “Diagnostics” dialog.
The pass count is shown in the “PASS” field.
■ In case of FAIL
“NG” is shown in the “Result” field on the “Diagnostics” dialog.
The pass and error count are shown in the “pass” and “error” fields respectively.
Name of file being verified
ddddddddddddddddddddd