NO.
CONT.ON 30 PAGE NO.29
■ In case of PASS
“OK” is shown in the “Result” field on the “Diagnostics” dialog.
The pass count is shown in the “PASS” field.
■ In case of FAIL
“NG” is shown in the “Result” field on the “Diagnostics” dialog.
The pass and error count will be shown in the “pass” and “error” fields respectively.
The detail of the error will be recorded to the WPETD log file as below.
Message Explanation
Memory compareerror( MEMORY Test 1) An error occurred during MEMORY Test 1.
Memory compareerror(MEMORY Test 2) An error occurred during MEMORY Test 2
Memory compareerror(MEMORY Test 3) An error occurred during MEMORY Test 3
4-2-4 USB STORAGE Test
This test checks if the connection of the USB Ports on the PC works by using a USB Memory.
You need to prepare a USB Memory.
The test writes some data to the USB memory. The USB memory needs at least 12 MB free space.
Note:
The current version of the test does not check if the connection level is whether USB3.0 or USB2.0/1.0.
We recommend you to use a USB2.0 Memory for this test.
1) Test contents
The test detects a USB Memory plugged to one of the USB ports on your PC. Then the test copies some data to the USB Memory,
read the data back from the memory and compare it to the original data. If the comparison is OK, the test will say that the port is
passed.
Important Note
Do not take WPETD USB Memory out during USB STORAGE Test trying to check the port that WPETD USB Memory plugged in.
Recognize that the USB port works fine as long as WPETD has launched.
Again, when you launch WPETD from WPETD USB Memory, you must not take the USB Memory out of the USB port. If you do so,
the WPETD’s behavior will be unstable and it will not be guaranteed.
2) Test screen
▼ Drive information … The drive letter of the USB being tested
▼ Test item … The test item being executed: File Access test.
▼ Progress status … The test progress
3) Result
Progress status
Drive information
Test item
To Next Page
Loading...
