Dynacord DDL 204 - Switching the Unit on; Level Setting

4. START-UP
4.1 SWITCHING THE UNIT ON
1 The DDL 204 is switched ON via the POWER switch
(13).
POWER
2 The following appears on the display:
3 Subsequently the DDL 204 is ready for operation
and is in Play Mode. The following may appear on
the display:
The display means that you are in program 01. The
delay time for output 1 is adjusted to 200 msec., for
output 2 to 400 msec., for output 3 to 600 msec, and
for output 4 to 800 msec. The configuration can be
seen on the status LED's MONO 1 -IN-4 or STEREO
1 -IN-2.
DYNACORD DDL 204
SIGNAL DELAY
PH 200
2 400 [01
ED 600 4J 800 ms
NOTE!
If the display on the right side appears after the unit has
been switched on, you should contact the service center
to change the internal battery.
In this case the battery voltage has dropped below a min.
value and there is no guarantee as to whether your
program data will be maintained in the memory after
switching off the unit.
V_V
Service Required
Chng. Int. Battery
4.2 LEVEL SETTING
1 With the INPUT controls (1) you can adjust the DDL
204’s input levels for the channels 1 and 2 to the
desired value.
2 While the level is being adjusted via the INPUT
controls (1), keep checking the maximum indication
on the level meters (2). The optimum value is 0 dB.
The CLIP LED’s indicate internal overdriving and
should on no account light up.
_R -3
-ft .3
6
INPUT 2
CD CLP CD
CD *3 CD
□ O □
CD -3 CD
CD -8 CD
CD -12 CD
CD-* CD
CD -24 CD
■ M M2
4-1