Dynacord DDL 204 - Page 8

5.2 EDITING
Delay configurations and parameters are altered in EDIT
mode. For a description of all parameters please turn to
chapter 6.
1 Press the EDIT key (5).
2 You are now in EDIT Mode. The EDIT LED lights up
and the name and the value of the first parameter in
the active program appear on the display. A graphic
indication of the parameter value gives constant
information as to one's current position in the para¬
meter range.
3 The rotary encoder (11) can now be used to alter the
parameter value. If you keep pressed the rotary
encoder during rotating, the parameter alteration is
accelerated (larger step width).
4 The set value appears on the display and the change
is immediately audible. The EDIT LED then blinks to
show that the program has been changed. If you do
not wish to alter further parameters, proceed directly
to point 7.
EDIT * SB-ECT ► " ENTER
5 The SELECT keys (6) and (7) take the user to the
next or previous parameter.
EOT 4 SELECT ► P*®* * ENTER
6 The following may appear on the display:
Points 3 to 6 can be repeated as often as required.
7 By pressing the key EDIT (5) again you change back
to Play Mode.
CAUTION! Your program alterations have not yet been
stored and will be lost at the next program change!
8 The program number and the delay setting appear
on the display. The EDIT LED continues to blink.
There are several different possible ways of conti¬
nuing:
— if you should wish to store the edited program in
a memory, proceed to chapter 5.3.
— if you should wish to continue to alter parame¬
ters, go back to step 1.
— if you should require the original program again,
press the rotary encoder (11) (=ENTER). The al¬
terations of the parameter values are thus dele¬
ted. The EDIT LED goes off.
1
Note:
You can change directly from the edit mode into the store
mode by pressing the key STORE (8)1
5-2