Need help?Do you have a question about the Dynacord L1600 and is the answer not in the manual?
General| Amplifier Technology | Class H |
|---|---|
| Output Power (4 Ohms Bridged) | 1600 W |
| Input Impedance | 20 kOhms |
| Damping Factor | > 300 |
| Frequency Response | 10 Hz - 40 kHz |
| Weight | 12.0 kg |
| Total Harmonic Distortion | < 0.03 % |
| Input Sensitivity | 1.4V |
| Protection | DC |
| Cooling | Front-to-rear |
| Connectors | XLR, Speakon |
| Dimensions | 483 mm x 88 mm x 384 mm |
Highlights risks like electric shock, fire, and moisture exposure, and precautions.
Covers reading instructions, cleaning, ventilation, and avoiding heat sources.
Addresses polarized/grounding plugs and power cord protection.
Details when to seek service and how to disconnect power.
Information on waste electrical and electronic equipment disposal.
Emphasizes that servicing is for qualified personnel only.
Mentions adherence to EN 60065, VDE 0860, IEC 65, and CSA E65-94.
Covers transformer use, power switch, minimum distances, and component replacement.
States that altering circuitry requires prior consent.
Introduces the DYNACORD LINEAR PRECISION SERIES for touring applications.
Details protection against overload, shorts, RF, and DC faults.
Describes robust chassis, torsion resistance, and quiet fan cooling.
Highlights excellent transmission, low distortion, and ample headroom.
Explains balanced XLR inputs, direct outs, and input routing modes.
Mentions detented gain controls and LED status indicators.
Covers output connectors, Hi/Lo cut filters, and groundlift switch.
Advises on load impedance, fan airflow, and rack mounting.
Describes detented potentiometers for adjusting amplifier gain.
Explains the LED indicating power status.
Details the LED for signal presence at the input.
Explains the LED for signal presence at the output.
Describes the LED for limiter activation and clip level operation.
Explains the LED for triggered protection circuits.
Details the main power switch and startup behavior.
Describes XLR inputs, electronic balancing, and input wiring.
Explains settings for DUAL STEREO and PARALLEL MONO modes.
Provides guidance for using unbalanced mixer outputs with XLR inputs.
Details SPEAKON output connectors for channels A, B, and Bridged Out.
Explains the adjustable limiter time constant (FAST/SLOW).
Describes switching to Mono Bridged mode for higher output.
Explains the function of the Hi-Lo-Cut filter and its ON/OFF positions.
Details how the groundlift switch prevents hum loops.
Lists output power ratings for different impedances and modes.
Details frequency response characteristics.
Indicates maximum output voltage before clipping.
States the voltage gain.
Provides input sensitivity levels.
Specifies maximum input signal level.
Lists input impedance.
Indicates Total Harmonic Distortion.
Shows SMPTE Intermodulation Distortion.
Details signal-to-noise ratio.
Specifies channel crosstalk.
Lists damping factor.
Shows DIM 30 levels.
Shows DIM 100 levels.
Indicates internal slew rate.
Provides power consumption figures.
Lists physical dimensions.
States the weight.
Mentions optional accessory.
Illustrates the internal signal flow and component connections for L300/L500/L100.
Depicts the internal signal flow and component connections for L1600/L2400.
Provides detailed physical dimensions in millimeters for various models.
To Next Page
