Need help?Do you have a question about the Dynacord L2400 and is the answer not in the manual?
Details on Level Controls and the Power Switch.
Explanation of Power ON, Input, Output, Limit, and Protect LEDs.
Description of XLR input connectors, PIN assignments, and wiring.
Explanation of DUAL/STEREO and PARALLEL/MONO input modes.
Details on SPEAKON output connectors for channels A, B, and Bridged Out.
Configuration of Limiter, Bridged Mode, and Hi-Lo-Cut Filter.
Function of the groundlift switch for hum reduction.
Details on Level Controls and the Power Switch.
Explanation of Power ON, Input, Output, Limit, and Protect LEDs.
Description of XLR input connectors, PIN assignments, and wiring.
Explanation of DUAL/STEREO and PARALLEL/MONO input modes.
Details on SPEAKON output connectors for channels A, B, and Bridged Out.
Configuration of Limiter, Bridged Mode, and Hi-Lo-Cut Filter.
Function of the groundlift switch for hum reduction.
General| Type | Power Amplifier |
|---|---|
| Output Power (4 Ohms Bridged) | 2400 W |
| Signal-to-Noise Ratio | > 100 dB |
| Power Consumption | 2400 W |
| Input Sensitivity | 1.4V |
| Input Impedance | 20 kOhms (balanced) |
| Protection | Thermal, short circuit, Overload |
| Connectors | XLR, Speakon |
| Frequency Response | 20Hz - 20kHz (±0.5dB) |
To Next Page
