Need help?Do you have a question about the Dynacord PAA 880 and is the answer not in the manual?
Specifies the nominal output power at an 8 Ohm load.
Specifies the nominal output power at a 4 Ohm load.
Details output power in bridged mode at 8 Ohm.
Specifies the total harmonic distortion level.
Set voltage drop to 200mV using the Idle Current Trimmer.
Adjust R027/R028 to minimum for compressor setup.
Specifies the nominal output power at an 8 Ohm load.
Specifies the nominal output power at a 4 Ohm load.
Details output power in bridged mode at 8 Ohm.
Specifies the total harmonic distortion level.
Set voltage drop to 200mV using the Idle Current Trimmer.
Adjust R027/R028 to minimum for compressor setup.
General| Type | Power Amplifier |
|---|---|
| Channels | 2 |
| Cooling | Fan-cooled |
| Output Power (bridged) | 800 W |
| Frequency Response | 20 Hz - 20 kHz |
| Total Harmonic Distortion (THD) | < 0.1% |
| Signal-to-Noise Ratio | > 100 dB |
| Input Impedance | 20 kOhms (balanced), 10 kOhms (unbalanced) |
| Protection | Short circuit, thermal |
| Power Supply | 230 V |
To Next Page
