Need help?Do you have a question about the Dynacord PAA 990 and is the answer not in the manual?
Minimal distances for voltage carrying parts and mains terminals are 6mm and 3mm respectively.
Use only original parts and do not make unauthorized circuit modifications.
Steps to open the unit including screw removal and bracket use.
Specified output power at different impedances and configurations (stereo/bridged).
Testing DC protection and short circuit protection circuits under various load conditions.
Procedures for idle current and compressor adjustments.
Comprehensive list of spare parts with descriptions and part numbers.
Detailed schematic diagram of the Dynacord PAA 990 amplifier.
Minimal distances for voltage carrying parts and mains terminals are 6mm and 3mm respectively.
Use only original parts and do not make unauthorized circuit modifications.
Steps to open the unit including screw removal and bracket use.
Specified output power at different impedances and configurations (stereo/bridged).
Testing DC protection and short circuit protection circuits under various load conditions.
Procedures for idle current and compressor adjustments.
Comprehensive list of spare parts with descriptions and part numbers.
Detailed schematic diagram of the Dynacord PAA 990 amplifier.
General| Type | Power Amplifier |
|---|---|
| Channels | 2 |
| Input Impedance (balanced) | 20 kOhms |
| Input Impedance (unbalanced) | 10 kOhms |
| Protection | DC, Short Circuit |
| Power Requirements | 50/60Hz |
| Dimensions | 483 x 132 x 430 mm (19" x 5.2" x 16.9") |
To Next Page
