Dynacraft Hello Kitty - Steering Wheel Assembly; Windshield Assembly; Seat Assembly

2. Steering Wheel Assembly
● Put the vehicle body upright.
● Remove the M5 × 35 machine
sc
rew and Ø5 nut from the
steering wheel.
● Insert the steering wheel to the
end of the steering column.
● Insert the M5x35 machine
screw through the steering
wheel and steering column
(make sure to align their holes),
then tighten securely.
3. Windshield Assembly
● Fit the tabs on the windshield
into the slots in the vehicle as
shown.
● Insert four Ø4x12 round head
screws and tighten with a
screwdriver.
4. Seat Assembly
● Insert the tabs on the back of
seat into the slots in the
vehicle
body.
● Insert two M5x16 machine
screws, and tighten securely
with a screwdriver.
10