BEFORE YOU BEGIN ASSEMBLY
WARNING
Remove all packing and items from the display box. Make sure that the power switch
is turned “OFF” before assembling the electric ride
-on toy.
ESTIMATED ASSEMBLY TIME
You should allow approximately 25 minutes for assembly, not including initial
charging time. Initial charging can take approximately 18 hours. (see page 13-14 for
charging information).
WARNING: DO NOT USE NON-ORIGINAL OR
NON-RECOMMENDED PRODUCTS WITH YOUR
ELECTRIC RIDE-ON TOY.
Altering of the original components or use of non-recommended
replacement parts may or may not be compatible with the design and will
void the warranty and may cause an unsafe condition resulting in serious
injury or death.
6
NOTICE
The battery is disconnected for shipment to prevent the battery from draining. Before
you begin assembly, make sure to plug the battery connector into the control module
connector (see figure 1).
Hint: If the battery connector will not plug into the control module connector, turn it
over and try again, making sure that the two connectors are properly aligned. Do not
force the battery connector into the control module connector.
NOTE: BATTERY LOCATED UNDER SEAT.
To Next Page
Loading...
Need help?
General
