DETAILED MAINTENANCE AND REPAIR
Turn po wer “ OFF” before conducting any maintenance procedures.
Tools Required:
Flat head Screwdriver
(not included)
17mm Socket Wrench
(not included)
HOW TO REPLACE FRONT WHEELS
1.
2.
3.
4.
5.
18
Remove the Axle Cap with a flat head screwdriver.
Remove the M10 locknut with a 17mm socket wrench.
Remove the Ø10 washer.
Remove the wheel, then replace with a new one and make sure the Ø10 bushing
sits inside the wheel.
Remount the Ø10 washer, M10 locknut and securely tighten the wheel; then
re-insert the axle cap.
To Next Page
Loading...
