14. Install Steering Wheel Batteries
(Note: Batteries not included)
● Loosen the screw in the steering
wheel and remove the cover.
● Insert 2 x 1.5V size AA AM-3 or LR6
batteries as shown.
● Replace the cover and tighten the
screw to secure it in place.
Bat
tery Safety Information:
Batteries may leak fluids that can cause chemical burn injury or ruin your product.
To avoid battery leakage:
●
Install batteries correctly, observing the
polarity (+,-) signs to avoid leakage.
●
Do not mix old and new batteries.
●
Do not mix batteries of different types:
alkaline, standard (carbon-zinc) or
rechargeable (Ni-MH).
●
Remove the batteries from the
battery compartment when the unit
will not
be used for an extended
period of time.
●
Always remove exhausted batteries
from the battery compartment.
●
Do not dispose of batteries in fire.
●
Do not short circuit the supply
terminals
.
●
Replace the batteries when the horn
sounds distorted.
●
Non-rechargeable batteries are not to be recharged.
●
Use only batteries of the same or equivalent type as recommended.
●
If removable rechargeable batteries are used, they are only to be charged
under adult supervision.
●
Remove rechargeable batteries from the product before charging.
●
Battery chargers used with toys must be examined regularly for damage to
the cord, plug, enclosure and
other parts. In the event that such damage is
found, the toy must not be used with the battery charger until
the damage
has been repaired.
11
12. Seat Assembly
● Insert the tabs on the the back of seat
into
the slots in the
vehicle body.
● Insert two M4x12 machine screws, and
tighten securely with a screwdriver.
13. Rear Bar Assembly
Insert the rear bar onto the tail of the
vehicle in the correct direction as
shown, and push down on the rear bar,
to secure it on the vehicle as shown
(using two 4x12 round head screws).
●
To Next Page
Loading...
Need help?
General
