ASSEMBLY
Your new vehicle requires adult assembly. Please set aside around 35
minutes for assembly. Please identify all parts before assembly and save all
packaging material until assembly is complete to ensure that no parts are
discarded.
Tools Required:
Phillips Screwdriver
(not included)
Standard slip joint pliers
(not included)
WARNING:
Children can be harmed by small parts, sharp edges and
sharp
points in the vehicle’s unassembled state, or by electrical items. In the
unassembled
state, this package contains small parts. Adult assembly is
required; children should
not handle parts, or help in assembly of the vehicle.
1. Front Wheel Assembly
● Turn the vehicle body upside down.
● Remove all parts from front wheel axle.
● F
Slide a wheel and wheel cover onto the
axle (make sure tabs on the wheel cover
fitted into holes on the wheel).
it a Ø10 washer onto the axle.
●
●
Install a Ø10 washer and locknut, tighten
it.(Note: Dot not over-tighten)
● Fasten the axle cap. .
● Repeat above operation for another side
of front wheel.
2. Rear Axle Assembly
● Turn the vehicle body upside down.
Remove all parts from rear axle.
Insert the rear axle through the hole in the
vehicle body.
Slide a 10 washer onto the rear axle from t
the longer end.
●
●
●
8
17mm Socket Wrench
(included)
Ø
To Next Page
Loading...
Need help?
General
