Need help?Do you have a question about the DynaGen Tough Series and is the answer not in the manual?
Provides essential guidelines for connecting wires to the controller for safe and effective operation.
Lists and describes the function of each terminal on the main and expansion connectors.
Details the different wiring harnesses and their terminal connections for various components.
Illustrates a typical wiring setup for the TG350 controller and its components.
Shows a typical wiring diagram specifically for the TG350 controller when used with a RelayPak.
Details the wiring required for implementing an emergency stop function for immediate shutdown.
Provides guidelines for connecting the controller to a CAN bus engine for communication.
Describes the optional RelayPak, its specifications, and usage for expanding I/O capabilities.
Details the different operational states and methods for starting the engine.
Outlines the various ways the engine can be started using the controller.
Details the cooldown mode functionality, including how it affects engine operation and start commands.
Describes conditions that cause the controller to shut down the engine to prevent damage.
Configures five switched inputs to perform specific functions when activated.
Provides an overview of sensor inputs and their configurations for engine monitoring.
Configures the controller's internal clock and timing functions for various operations.
Provides settings for configuring the controller's AC monitoring capabilities.
Details the controller's communication capabilities with other systems.
Contains miscellaneous settings not covered in other sections.
Provides solutions for issues where the engine crank output fails to disengage after starting.
Explains how to resolve the "Failure To Stop" message by adjusting Energize to Stop settings.
General| Number of Digital Inputs | 8 |
|---|---|
| Number of Analog Inputs | 4 |
| Storage Temperature | -40°C to +85°C (-40°F to +185°F) |
| Communication Ports | RS-485, Ethernet |
| Protocols | Modbus RTU, Modbus TCP/IP |
| Enclosure | IP65 |
| Input Voltage | 24V DC |
| Output Voltage | 24V DC |
To Next Page
