What to do if Measuring Head malfunction in DynAmp Measuring Instruments?
If the Measuring Head of your DynAmp Measuring Instruments isn't working correctly, measure the head input signals when the bus current is zero. The output should be less than 5mVdc. If it's not, try substituting it with a known good Measuring Head.
How to fix head imbalance on DynAmp LKAT2?
To resolve head imbalance in DynAmp Measuring Instruments, adjust the position of the head until the green light is ON and the red light is OFF.
What to do if head halves disconnected in DynAmp LKAT2?
If the head halves of your DynAmp Measuring Instruments are disconnected, check the head interconnections at the Metering Unit to ensure they are properly connected.
How to check no input power on DynAmp LKAT2?
If your DynAmp Measuring Instruments are not receiving input power, begin by checking the input power connection to ensure it is properly connected.
How to check DC power supply on DynAmp LKAT2 Measuring Instruments?
To resolve DC power supply issues with your DynAmp Measuring Instruments, verify the DC power on the main PCB.
Covers general safety rules for technicians and symbol identification.
Addresses hazardous voltage and installation environment requirements.
General introduction to the LKAT² system and its capabilities.
Describes the physical components of the LKAT² system.
Explains the visual indicators and output signals of the Metering Unit.
Describes the power input and system output cable assemblies.
Safety and preparatory steps before installation.
Factors to consider before mounting the Measuring Head.
Detailed steps for installing the Measuring Head on the bus bar.
Guidelines for selecting and installing the Metering Unit location.
Steps to verify proper installation and initial system operation.
Details the Open-Loop, Open-Path technology and system overview.
Guides on diagnosing and resolving accuracy fault indications.
Discusses calibration intervals and methods for the LKAT² system.
Summarizes the calibration adjustments for Bias, Zero, Scaling, and Gain.
Explains how to reconfigure trip setpoints and polarity in the field.
Describes the earth ground connection path and its purpose.
Details how to set up the low pass filter using switches.
Explains the failsafe and non-failsafe configurations for alarm relays.
Covers periodic and annual maintenance tasks.
Lists recommended spare parts for the LKAT² system.
General| Brand | DynAmp |
|---|---|
| Model | LKAT2 |
| Category | Measuring Instruments |
| Language | English |
To Next Page
