Why is there no image on my Dynascan DS491LT6 Digital Signage?
If no image is displayed on your Dynascan Digital Signage, verify that the cable is completely plugged in and not damaged or bent excessively. Also, ensure the main switch is in the ON position, the power cord is properly connected, and the image source resolution is a supported format.
What to do if the Dynascan DS491LT6 remote control does not work?
If the remote control for your Dynascan Digital Signage isn't working, first check if batteries are present and have the correct polarity. Ensure the batteries are fresh and that you are within the remote's operational range. Bright light sources, like fluorescent or neon lights, may interfere with the remote; avoid using it near these.
What to do if auto on/off does not work on Dynascan DS491LT6?
If the auto on/off function on your Dynascan Digital Signage isn't working correctly, verify that the TIMER setting in the menu is not set to “OFF”. Also, confirm that the “Power On Time” and “Power Off Time” settings are correctly configured.
General| Display Type | LCD |
|---|---|
| Screen Size | 49 inches |
| Resolution | 1920 x 1080 (Full HD) |
| Viewing Angle | 178° (H) / 178° (V) |
| Operating Temperature | 0°C to 50°C |
| Response Time | 8 ms |
| Storage Temperature | -20°C to 60°C |
| Power Consumption | 120 W |
| VESA Mount | 400 x 400 mm |
| Connectivity | HDMI, VGA, USB |
| Input Ports | HDMI, VGA, USB |
To Next Page
