To Next PageTo Next Page
Need help?Do you have a question about the DYNATEK DFCH-1 and is the answer not in the manual?
General| Product Type | Ignition Coil |
|---|---|
| Primary Resistance | 3 ohms |
| Inductance | 8.5 mH |
| Mounting Style | Bolt-On |
| Type | High Performance |
| Input Voltage | 12 V |
| Compatibility | Harley-Davidson |
Remove or raise the fuel tank to access fuel injectors and TPS wires.
Connect FI Controller injector connectors to the bike's front and rear injectors.
Locate the TPS connector situated behind the throttle body.
Crimp the FI Controller's grey wire onto the TPS grey/purple stripe wire tap.
Route the wiring harness from the engine to the seat, securing it away from the cylinder head.
Mount the FI Controller under the seat, connect ground, and attach with Velcro.
Four preprogrammed curves adjust fuel delivery based on throttle position and RPM.
Adjust fuel delivery +/- 20% in Low, Mid, and High RPM ranges using rotary controls.
Select the correct base curve and fine-tune with potentiometers, not while riding.
Check power and ground connection if the STATUS LED does not illuminate.
Verify injector connections are seated properly if the engine runs on only one cylinder.
