Need help?Do you have a question about the DYNATEK Dyna 4000 Super Pro DP4000-HD1S and is the answer not in the manual?
General| Brand | DYNATEK |
|---|---|
| Model | Dyna 4000 Super Pro DP4000-HD1S |
| Category | Motorcycle Accessories |
| Language | English |
Details the Dyna 4000 Super Pro as a next-generation drag race ignition, refining the Dyna 4000 Pro with enhanced features.
Explains the system's design for long spark duration and high spark energy, delivering four times the spark energy of CD boosters.
Highlights the smooth two-stage rev limiter for launch control and over-rev protection, emphasizing consistency.
Covers essential requirements like heavy gauge ground wire and suppression spark plug wires to prevent interference.
Explains the two configurations for Harley ignitions and how the Dyna 4000 can be used in either mode.
Specifies the correct DYNATEK coils (DC9-3 for single fire, DC9-1 for dual fire) required for proper operation.
Details mounting the DC9-3 Twinfire coil and connecting spark plug wires for single cylinder ignition.
Outlines mounting the DC9-1 coil and connecting wires for dual cylinder ignition using a single coil.
Guides on connecting the main harness legs for crank trigger, clutch switch, tach output, and ignition enable functions.
Covers direct battery connection for power and installation of air kill switches for ignition interruption.
Specifies the need for a special blue two-magnet rotor for proper system function and pickup sensing.
Explains how to statically time the motor using the ignition module's LED and the crank trigger magnets.
Details how to set the low and high rev limiters using the module's knobs and how they function with the clutch lever.
Describes the benefits and connection of the DRD-1 Remote Display for expanded rev limit adjustment and monitoring.
To Next Page
