TECHNICAL SUMMARY
DYNATRON SOLARIS
®
PLUS SERIES | SERVICE MANUAL REV. 6 | AUGUST 29, 2017 128
Technical
Summary
Setting Defaults
Each of the modalities has default settings that are automatically selected when a modality key is pressed. e default settings
feature allows previously used treatment parameters to be set up in just seconds. For guidance in selecting the appropriate
settings for each modality, consult published medical literature.
Save New Defaults
If your most common treatment settings are dierent than the ones already set for this device, you can change the defaults
to suit your own preferences. Setting new defaults is simple and defaults may be changed again and again whenever needed.
1. Press the modality key desired (IFC, Premod, Russian, Biphasic, High Volt, Micro, Direct Current, Sound, or Combo).
2. Set up a treatment using your preferred settings.
3. If this is an actual treatment you may increase the intensity now (intensity is not saved with the default settings). is
step is optional.
CAUTION
• Do not use Ohm meters on Solaris Plus devices. Ohm meters will damage the Solaris Plus processors.
• ere are no serviceable parts in the Solaris Plus devices.
To Next Page
Loading...
