Dynaudio DBM50 User Manual

8
MISCELLANEOUS
Troubleshooting
If Power LED lights green and no sound, check
your input signal i.e. by switching speakers.
Care
Components of the highest quality is used in
yourDBM50.Thisassuresyearsoftroublefree
operation. Following precautions should still be
made though.
Avoid running the system into severe clipping.
Even there is an advanced protection system,
you may be able to destroy your speakers by
severe overpowering. The limiter works over
a certain range, but exceeding this level may
send a severely clipped signal to your drivers.
When a noticeable distortion occurs, please
turn down the level to your speakers.
Avoid hot plugging the equipment connected to
the monitors. Always turn off the speaker and
other equipment when plugging or unplugging
signals, or switching equipment on or off.
Do not touch the drive units by hand. The
tweeter especially uses a very fine fabric dome
with a ultra thin coating.
Options
TheDBM50maybecombinedwithaDynaudio
Acoustics subwoofer for extended bass
performance, and higher spl if high-pass filter is
used. See Setting Up.
Service
There are no user serviceable parts inside the
monitor. If service is required please contact
service via:
www.tcsupport.tc
or
TC Electronic
Sindalsvej 34
DK-8240 Risskov
Denmark
Tel: +45 87427000
DBM50_prelim_2402_2012.indd 8 15-03-2012 14:36:14

Dynaudio DBM50 Specifications

General

Brand	Dynaudio
Model	DBM50
Category	Speaker System
Language	English