3938
loudspeakers with the CS-PA1. Make sure that bare
loudspeaker cables can never touch each other or
the back wall of the housing! Only use loudspea-
kers with a nominal impedance of at least 4Ω.
One pair of loudspeakers may be connected to the
amplifier. You will find two loudspeaker clamps
(positive + and negative -) for each loudspeaker
(R: right and L: left) on the device (12), these
clamps have to be connected to one end of a loud-
speaker cable. There are identical or similar connec-
tors on the loudspeakers and here too the polarity
is stated. This is where the other end of the loud-
speaker cable assigned to the loudspeaker is con-
nected. In each case, the same polarity must be
connected by each loudspeaker wire: the clamp
marked with "+" on the amplifier must be connec-
ted with the connector marked with "+" on the
loudspeaker.
The loudspeaker cables must be attached directly,
without using cable connectors. Remove a piece
of the insulation about 1 cm long from each end of
the loudspeaker wire. Twist the bare wire in order
to prevent short circuits. Press the knob of the
loudspeaker clamp to open it and feed the bare
wire end into the clamp hole now exposed.
Now release the knob to secure the wire in the
loudspeaker clamp.
Connection of the mains cable
Do not connect the mains cable until last. Connect
its power plug to a mains socket which is supplied
with an appropriate voltage (230 V/50 Hz). Do not
switch the device on until after you have adjusted
the volume control (4) in anticlockwise direction to
the minimum volume.
To Next Page
Loading...
Need help?
General
