29
1. POWER STANDBY
Switches the device on and off. When switched off,
the device is disconnected from the mains. The LED
located next to the switch lights up when the devi-
ce is switched on.
2. MIC INPUT
You can if you wish connect a dynamic microphone
to this jack socket. You must not attach a high level
source here under any circumstances!
3. MIC VOL
With this volume control you set how loud the
microphone signal is mixed into the input signals at
the “AUDIO INPUT” (9) connectors. This is only for
Speaker OUT, not for Rec OUT!
4. DIGITAL ECHO
With this dial you set the intensity of the echo
affecting only the microphone signal.
5. BASS
For setting the bass proportions (low frequencies)
of the sound.
6. TREBLE
For setting the treble proportions (high frequencies)
of the sound.
7. LOUDNESS
This button activates and deactivates a sound
correction that adapts the speaker audio signal to
the human auditory sensation in the lower volume
range.
8. VOLUME
The volume of the loudspeakers may be increased
or decreased with this.
To Next Page
Loading...
Need help?
General
