Jbus MODbus Description Display Attribute
Address Address Code
130 129 Status alarm 2 R
Range:
0 = No alarm
1 = Alarm
*131 130
Alarm 1 threshold RWDM
*132 131 Alarm 2 threshold RWDM
134 133 Input variable without filter RDM
Notes: When an error is detected on
measure, the”Data field” contains one
of these error codes:
30002 (7532h) = Open sensor ckt
30004 (7534h) = Under-range
30005 (7535h) = Over-range
30050 (7562h) = Error on internal auto-zero
30053 (7565h) = Calibration span too small
(<= 7% of input span)
*218 217 Lock/unlock device status RW
Range:
0 = Unlock device
1 = Lock device
*219 218 Local/remote device status RW
Range:
0 = Device in local
1 = Device in remote
Notes: See note 6 at page 40.
220 219 Unsolicited request flag R
Range:
0 = No Parameters change has occurred
1 = change has occurred on parameters
marked with *Notes: The word is set at
the start-up. Changes produced by serial
link will not be flagged.
The word resets after reading.
44
To Next Page