14
Format: 1 start bit, 8 bits with or without parity, 1 stop bit
Parity: Even/Odd.
2.9 CONTROL OUTPUT SPECIFICATION
Control Output: Opto-isolated from CPU input and output circuits.
Type of Analog Output: Jumper and keyboard selectable between:
•+ 0/10 VDC min. load 5 K⏲
•- 10/+10 VDC mm. load 5 K⏲
•+ 0 / 5 VDC mm. load 5 K⏲
•+ 0/20 mA max. load 500⏲
•- 4/20 mA max. load 500⏲
Resolution: 0.1% in manual mode, 0.03% in automatic mode.
Scaling: The output control value may be displayed in two modes:
• from 0.0 to 100.0% (0.1% resolution)
• from a low to a high limit selection from - 10000 to 10000
2.10 RETRANSMISSION OUTPUT SPECIFICATION
Retransmission Output: Opto-isolated from CPU input and output circuits.
Type of Analog Output: Jumper and keyboard selectable between:
•+ 0/10 VDC min. load 5 K⏲, with under / overrange capability from -2.5 to 12.5 V.
• ± 10 VDC min. load 5 K⏲, with under / overrange capability from -12.25 to 12.5 V.
•+ 0/5 VDC min. load 5 K⏲, with under / overrange capability from -1.25 to 6.25 V.
•+ 0/20 mA max. load 500⏲, with under / overrange capability from 0 to 24 mA (max. load 400
Ohm over 20 mA).
•+ 4/20 mA max. load 500⏲, with under / overrange capability from 0 to 24 mA (max. load 400
Ohm over 20 mA).
Resolution: 0.1% of output mode
Scaling: The retransmission low and high limits are selectable from 0 to full scale input value. The
two scaling values may be freely selectable within the above range. This allows for a direct or
reverse output type.
Output Filter: Selectable from the following values: OFF, 0.4 s, 1 s, 2 5. 3 s. 4 s, 5 s.
To Next Page
Loading...
Need help?
General
