DYON SMART 43 X-EOS
21
8 Initial setup
This screen is only displayed, when the TV is turned on for the
first time or reset to the factory default setting. Press the OK
button to start the initial installation.
8.1 Language and Location
Mark the language selection and press the OK button. Select
the desired language by using the / buttons and confirm
your selection with the OK button.
Mark the country selection and press the OK button. Select
your country with the / buttons and confirm your selection
with the OK button. Now mark "Next" and press the OK button
to continue.
If you select "Exit first use", you will exit the first use and the
other settings will be automatically set to default values and you
will skip the initial setup.
Note
Before you proceed, please make sure that the
receiver/antenna cable is connected.
Note for the usage of the Magic Remote
Scroll on the mouse or press the OK button to activate
the remote control. Now you will see the pointer on the
screen. If the pointer has not been used for a certain
time, the pointer disappears. Use the remote control
within the range of max. 10 meters.
To Next Page